The 3D interferometer is effective and cost-effective 0°, 8° APC angle adjustment Automatic focus, automatic calibration, automatic measurement Accurate and rapid, extremely high repeatability and reproducibility
Certified by national insitute of metrology. The test results are more accurate and reliable.
It can display 2D interference diagram and 3D end face diagram at the same time, which is convenient for engineers to analyse the end face and make grinding improvements.
Equipped with automatic inductive measurement module, you only need to insert the connector into the chuck and tighten it, no other operation is required. The device automatically starts the measurement and it takes only 0.4 seconds to test a sample.
There is no need to manually adjust the X and Y axis reference mirrors ， making calibration easier and faster.
There is no need to manually find the fiber center, and only normal measurement is needed to automatically find the fiber center
The user only makes normal measurement and it will automatically adjust the interference fringe to the clearest state, which greatly simplifies the measurement operation.
Even if there are dirty points on the fiber end-face, the equipment can still measure and calculate the accurate results, and the unique seismic design makes it applicable in a variety of complex operating conditions.
Instrument selection and performance indicator table
Note: ① All the above models +X is the fiber height extension model, and the extended range is |7000|
② Increase angle feedback system at *, the control accuracy is up to 0.0027 °